Kyocera Unimerco 16mm dia x 25mm cut CNC PCD Diamond Router Z=1+1 S=16 Up/Down Compression Right Hand Rotation
The tool sizes are as follows:-
Cut Diameter (D) = 16mm
Shank Diameter (S) = 16mm
Cut Length (I) = 25mm
Z = 1+1
Used for grooving, jointing, rebating, or general sizing of chipboard and MDF-board either raw laminated or veneered.
These tools are designed to give optimum cutting quality due to the huge shear angles of each tip segment alternating up and down along the cutting edge.
They can be resharpened several times which leads to economic efficiency and further cost savings.
The one plus one tip design gives an effective staggered cut and allows large gullet areas for chip removal.
These tools have long tool life built into them and use a large 2.5mm deep diamond segment for each tip. At the bottom of the tool there is a single Tungsten Carbide plunge tip for ramp plunging operations.
We stock a wide range of these cutters in Z=1+1, Z=2+2 and Z=3 Turbo in all diameters and cut lengths.
Our in-house CNC commissioning engineer Jeremy Appleby will be happy to provide Free Of Charge assistance to optimise your applications / parameters.
|Cut Length||20 - 29mm|
|Qty of Flutes||1+1 Wing|
|Chip Flow||Up / Down Compression|
|Feed Rate||5 - 10m/min|